HME DX100 Portable Digital Wireless Intercom

dx100-square.jpg
dx100-square.jpg

HME DX100 Portable Digital Wireless Intercom

0.00

The DX100 allows up to 15 people to speak to each other via headsets without any interconnecting cables. 

Much better than walkie-talkies – you can seamlessly communicate in hands-free mode or have a private conversation on a secured channel.

Simple and expandable, the DX100/100C comes complete with everything you need for reliable, cost-effective operation for any application.

Enquire

SPECS:

  • Frequency Range: 2400 – 2483.5 MHz
  • Frequency Response: 200 Hz to 3.5 kHz
  • Power Requirements: 100-240VAC, 50-60Hz or 12-14VDC
  • Temperature Range: 32-122°F (0-50°C)
  • Size: 10.2” x 6.45” x 3.33” (1-RU) (25.91 x 16.38 x 8.46 cm)
  • Weight: 2.35 lbs. (1.07 kg)
  • Maximum # of Beltpacs per Base: 15 can be registered Any 4 can have simultaneous full-duplex communication at one time. Others would be listen-only until a channel becomes available.
  • Front Panel Controls: Power, Register Beltpac, Reset, Unlatch and Clear Registration buttons
  • Front Panel Indicators: Registration Status display, Power and Receive LEDs
  • Antenna Type: External ½ -wave dipole (R-TNC connector) RX/TX horizontal/vertical diversity
  • System Distortion: <2%
  • Communication Security: 64-bit encryption dual-slot diversity
  • Splash Resistant: IEC529 IP Code 4 (under battery operation only) 

Transmitter

  • Type: Frequency hopping, spread spectrum
  • Transmit Power: 100mW burst
  • Modulation Type: Gaussian filtered FSK, TDM
  • Frequency Stability: 13 ppm
  • Harmonics/Spurious: Exceeds FCC and ETSI specifications over temperature

Receiver

  • Type: Frequency hopping, spread spectrum
  • RF Sensitivity: <−90dBm w 10-3 BER
  • Frequency Stability: 13 ppm
  • Distortion: <2%